应及时清理机器台面上的刨花、木屑。严禁直接用手清理。刨花、木屑应存放到指定地点。
1.The machine should be cleaned the table of wood shavings and sawdust in a timely manner. Direct hand cleaning is prohibited. Wood shavings and sawdust should be stored to the designated location.
2.作业前试机，锯切机械各部件运转正常后方可作业。开机前必须将机械周围及脚下作业区的杂物清理干净，必要时应在作业区铺垫板。
Work before the test machine, the operation of the normal operation of the parts before the operation. Before starting the machine must be around and at the foot of the operating area of debris clean up, if necessary, should be in the operating area bedding.
3.作业时必须扎紧袖口、理好衣角、扣好衣扣，不得戴手套。作业人员长发不得外露。女工应戴工作帽。
3.The operation must tie cuffs, good clothes, buttoned up, not wearing gloves. Operators long hair may not be exposed. Women workers should wear a working hat.
4.机械运转过程中出现故障时锯切机械，必须立即停机、切断电源。
4.In the process of mechanical operation, it is necessary to stop and cut off the power supply immediately.
5.链条、齿轮和皮带等传动部分，必须安装防护罩或防护板。
5.The transmission part of the chain, the gear and the belt must be fitted with a shield or shield.
6.必须使用单向开关，严禁使用倒顺开关。
6.Must use a one-way switch, the use of reverse switch is strictly prohibited.
7.木工机械 http://www.jndongjun.com/工作场所严禁烟火，必须按规定配备消防器材。
7. woodworking machinery working place is strictly prohibited fireworks, must be equipped with fire equipment.
8.木工机械 http://www.jndongjun.com/操作人员应经过培训，了解机械设备的构造、性能和用途，掌握有关使用、维修、保养的安全技术知识。锯切机械电路故障必须由专业电工排除。
8.woodworking machinery operators should be trained to understand the structure, performance and use of mechanical equipment, master the use of the use, maintenance, maintenance of security technology knowledge. Circuit fault must be excluded by professional electrician.
9.木工机械作业后必须切断电源，锯切机械闸箱门锁好。
9.woodworking machinery must be cut off after the operation of power supply, lock box door lock.
上一条：刃磨机械的流程操作和方法
下一条：如何做到保护铣削机械的措施
微信扫一扫二维码，关注厂厂乐服务号
400-618-8805 
